‘Scoreduino-A’ Trigger Module For Up and Down Counter Drivers

The video will show a different SCOREDUINO-A module. Both are electronically same, just the look is different.

The ‘SCOREDUINO-A’ module works as a basic controller for up and down counters or seven-segment display drivers. It has 3 switches for up, down, and reset signals. Up switch increases the count and down switch decreases the count and the reset switch resets the count to zero.

Other features:

• It has a Bluetooth module that communicates with the Scoreduino app and control signals can be sent to the Scoreduino devices from the app.

• It has a header for an RF module which makes it capable of receiving control signals from RF remote control.

Scoreduino is programmable like any other Arduinos. It requires an FTDI basic breakout board.

How does it work?

All seven segment display drivers are designed in such a way that this ‘Scoreduino-A’ module fits into the female headers of the drivers. The UP, DOWN and RESET pins of the trigger module connect to pins 5, 4, and 14 respectively of the 74LS192 chip that contributes to up, down, and reset of the count.

Scoreduino works with the following common anode seven segment display drivers. The seven-segment display drivers can be controlled by a Scoreduino Android app or RF remote control or the inbuilt switches.

All the drivers are designed for COMMON ANODE seven-segment displays. It can trigger these drivers:

1. 1.2 inch RED common anode seven segment display driver– works with 5V-6V. Works with other colors also after changing resistors.
2. 1.8 inch RED common anode seven segment display driver– works with 5V-6V. Works with other colors all after changing resistors
3. 2.3 inch RED common anode seven segment display driver– works with 9V. Works with other colors also after changing resistors.
4. 3 inch RED common anode seven segment display driver– Works with 12V. Works with other colors also after changing resistors.
5. 4 inch RED common anode seven segment display driver– Works with 12V. Works with other colors also after changing resistors.
6. 5 inch RED common anode seven segment display driver– Works with 15V. Works with other colors also after changing resistors.

Components used:

1. 1 x PCB
2. 1 x Bluetooth module
3. 1 x RF module
4. 1 x FTDI basic
5. 1 x 28 pin IC socket
6. 1 x Atmega328P-PU with Arduino bootloader
7. 4 x tactile switch
8. 1 x 5mm LED
9. 2 x 22pF
10. 1 x 16Mhz oscillator
11. 2 x 0.1uF capacitor
12. 1 x 500mA resettable fuse
13. 2 x 10uF capacitor
14. 2 x 6 pin angle male header
15. 1 x 6 pin male header for FTDI basic breakout board
16. 1 x 1P DIP switch
17. 1 x LM7805
18. 1 x heat sink for LM7805
19. 3 x 1K resistors
20. 2 x 10K resistors
21. 1 x PC817 optocoupler
22. 1 x DC barrel
23. 1 x buzzer
24. 1 x 16 pin IC socket
25. 1 x CD4049 chip

The Schematic:

See all the images on Flickr